Seecode 236321 Manual page 10

Operating the solar globe lamp
1. To switch on and off, press the switch slightly longer (approx.
2 seconds).
Note:
After switching on for the first time, the globe light adapts to
the current ambient light, lights up in the dark and goes out
in bright light. This means that the individual functions of the
globe light can only be tested or adjusted in a dark environ-
ment or when the solar field is covered.
2. Briefly pressing the switch changes the function modes
when the globe light is switched on:
Level Setting
1 25 % luminosity
2 10 % luminosity with motion sensor
Switches back to the initial state after 30 sec.
3 0 % with motion sensor
Switches back to the initial state after 30 seconds
4 100 % luminosity
10
Control light
Flashes 1 x
Flashes 2 x
Flashes 3 x
Flashes 4 x