Related Manuals for Mitsumi Z-Wave FGT-0001
Summary of Contents for Mitsumi Z-Wave FGT-0001
- Page 1 Z-Wave Window Sensor FGT-0001 User’s Guide Rev. 1.01 MITSUMI ELECTRIC CO., LTD.
- Page 2 Introduction This product is "FGT-0001" that detects the opening and closing of doors and windows that support Z- Wave Plus as standard. Detects changes in the state of the place where the product is installed and notifies the controller. This devices is a security enables Z-Wave Plus product that is able to use encrypted Z-Wave Plus messages to communicate to other security enabled Z-Wave Plus products.
- Page 3 Installation Please Work near the controller (within 1m). ■SmartStart SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code present on the product with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will be added automatically within 10 minutes of being switched on in the network vicinity.
- Page 4 ■Sliding type (for the sliding windows) Attach the magnet onto the window glass, and the sensor onto the window sash. ※ Allow a space of 10 mm from the top of this product. A Distance between the sensor and magnet shall not be greater than 10mm.
- Page 5 Sensor: 90 x 28 x 14.5 [mm] Magnet: 30 × 13 × 1 [mm] Mass Sensor: About 23g （excluding battery） Magnet: About 4.5g Z-Wave Overview Z-Wave+ Product Info ・Manufacturer: MITSUMI ・Z-Wave Device Type: Window Sensor Reachable Sleeping Slave ・Z-Wave Role Type: (RSS) ・Product ID: 0x0001 ・Product Type ID:...
- Page 6 On time within an On/Off period MANUFACTURER SPECIFIC Upon receiving a Manufacturer Specific Get request, it returns a Manufacturer Specific Report. Value Comment Manufacturer ID 0x0112 MITSUMI Product Type ID 0x0015 Window Sensor Product ID 0x0001 Windows Sensor Vol.1 NOTIFICATION Sends the reaction of the motion sensor to the controller.
- Page 7 POWERLEVEL Can be used under inclusion to test signal strength from the controller and to the device. VERSION This Command Class is used to get information about which version of the different command classes this product supports and the software version of this product. CONFIGURATION Set and check the configuration parameters to control this product.
Need help?
Do you have a question about the Z-Wave FGT-0001 and is the answer not in the manual?
Questions and answers