Table of Contents
Advertisement
LOCATION OF CONTROLS AND COMPONENTS
1) arta Indicator
@ *Dolby Noise Reduction
Switch (DOLBY NR)
5
@ Headphones Jack
[IN, OUT]
(PHONES) $3.5, 322
@ Tape Direction Buttons
s
© Volume Control
(REV &- FWD Vv)
=
12
(VOLUME)
@ Tape Selector (TAPE)
ais
=e,
© Band Selector
[NOR, CrO,/METAL]
Mis
OF)
© Battery Check Indicator @ pjayback Button
;
ua
(BATT)
A PLAY V
a:
i |
.
@ Function Selector
® aidan.
Couiae
Ry
(TAPE/OFF, RADIO]
Buttons (4 -J)
QO;
ff Rae
@
Tuning Control (Tuning)
.
RK
@ Clip Receptacle
y
E
8 pA
Ape
@ Battery Compartment
@ Cassette Compartment
a
NS
cn
*"Dolby" and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
Noise
reduction
system
manufactured
under
license
from Dolby Laboratories Licensing Corporation.
DISASSEMBLY INSTRUCTIONS
1. Remove two screws-A. (1.7x4) and
Fig. 2
Fig.
3
ia
eh
1. Remove two screws-B. (2x4)
2. es four screws-C. (1.74)
(Fig. 1), (Fig. 2)
3. Remove one screw-D. (2x10)
(Fig. 3)
C. How to remove the mechanism.
1. Pull off the plug-E (5p). (Fig. 5)
m When replacing the mechanism.
Push the reverse button to "REV"
position. (Fig. 5)
Front Cabinet
4. Remove the front cabinet in the
direction of arrow. (Fig. 4)
@ Note (How to replace the dial
E. How to remove the circuit
chassis)
D. How to remove the Dial
Dial Pointer
Chassis.
|
Dial Chassis
:
-
7
——— ll
Start Point
Fig. 7
When replacing the dial chassis.
1. Turn the dial gear and tuning nob
(Dial Chassis) to counter-clock
wise.
2. Set the dial pointer to start point.
1. Remove the knob in the direction
1. Remove one screw-F. (2x8) (Fig. 6)
(Fig. 7)
of arrow. (Fig. 8)
—
2? —
Advertisement
Table of Contents
