Do you have a question about the RT-420 and is the answer not in the manual?
Questions and answers
Donella Faye Davis
May 24, 2025
How to put codes in to program it
1 comments:
Mr. Anderson
May 26, 2025
To program an ATIS ID code into the NAVICOM RT-420:
1. Turn the radio OFF. 2. Long press the Hi/Lo/Lock button and turn the radio ON to enter ATIS mode. 3. The front digit shows the digit position; the blinking rear digit is the current value of the ATIS ID digit. 4. Use the UP/DOWN keys to change the rear digit. 5. Press the MEM key to confirm and move to the next digit. 6. After entering all 9 digits, enter the same ATIS ID a second time for confirmation. 7. If both entries match, the ATIS ID will flash once and the radio returns to the previous channel. If they don’t match, the process is canceled and must be restarted.
Need help?
Do you have a question about the RT-420 and is the answer not in the manual?
Questions and answers
How to put codes in to program it
To program an ATIS ID code into the NAVICOM RT-420:
1. Turn the radio OFF.
2. Long press the Hi/Lo/Lock button and turn the radio ON to enter ATIS mode.
3. The front digit shows the digit position; the blinking rear digit is the current value of the ATIS ID digit.
4. Use the UP/DOWN keys to change the rear digit.
5. Press the MEM key to confirm and move to the next digit.
6. After entering all 9 digits, enter the same ATIS ID a second time for confirmation.
7. If both entries match, the ATIS ID will flash once and the radio returns to the previous channel. If they don’t match, the process is canceled and must be restarted.
This answer is automatically generated