How To Manscape - Wahl MANSCAPER Instructions Manual

HOW TO MANSCAPE

1. Clean is important. Be sure your Manscaper
to perform the task with plenty of power available to do the job.
Also, make sure your hair is clean and dry for best results.
2. Use a comb to gently remove any snarls or tangles from your
pubic hair. Go slow at first until you get the hang of combing the
NetherScape to avoid painful pulls and jabs. After your hair is
clear of obstructing tangles, you are ready to start trimming.
3. Set the wrap-around guard dial to its longest position.
You will set it to progressively shorter lengths as you work your
hair into the style you want, but it's best to take off a little at a time.
4. Gently trim in the direction your hair naturally grows, and avoid cutting
against the grain as much as possible.
5. Using your free hand, pull your skin taught as
you get to shorter lengths to avoid folds of skin
entering the trimmer blade. See illustrations for
examples of what to do and what not to do.
6. Do the job, but don't over do it. To avoid
irritating sensitive skin, you will want to make
as few passes as possible as you get into the
shorter lengths. Remember to go gently and
take light strokes.
7. TAKE YOUR TIME. A fully charged
Manscaper will run for up to 100 minutes
TM
on a charge, so you have plenty of time to
go slow and get the job done right.
PRO TIP: After you perform your trimming, make sure to
clean up the mess. Nobody wants to walk into the bathroom
and find that all over the floor.
MANSCAPER TRIMMER
TM
is clean and ready
TM
13