ERICO MDRCPT-2 Instruction Sheet

INSTRUCTION SHEET
Manual DIN Rail Cutting and Punching Tool
559142 MDRCPT-2
A. Workbench:
WARNING:
1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
www.erico.com and from your ERICO customer service representative.
2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property damage,
serious bodily injury and death.
SAFETY INSTRUCTIONS: All governing codes and regulations and those required by the job site must be observed. Always use appropriate safety equipment such as eye
protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH and LENTON are registered trademarks of ERICO International
TECHNICAL SUPPORT
www.erico.com
4 x Ø9 mm
for M8 bolts
or
Corporation
IP8320A4_B2.DOC 1 of 7
2015 ERICO International Corporation