ERICO FLEXIBAR MFBT-2 Instruction Sheet

All manuals and user guides at all-guides.com
INSTRUCTION SHEET
® ®
ERICO FLEXIBAR
® ®
For ERICO FLEXIBAR ONLY
Manual ERICO FLEXIBAR Bending Tool
559145 MFBT-2
ERICO FLEXIBAR sizes [mm]:
6x20x1  10x120x1 or 12x100x1
A. Workbench:
3x 12mm
WARNING:
1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from your
ERICO customer service representative.
2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property damage, serious bodily
injury and death.
SAFETY INSTRUCTIONS: All governing codes and regulations and those required by the job site must be observed. Always use appropriate safety equipment such as eye protection, hard
hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH and LENTON are registered trademarks of ERICO International
Corporation
TECHNICAL SUPPORT:

www.erico.com IP8325A4_A 1 of 4 2015 ERICO International Corporation