Summary of Contents for Ubique Compact Dog Waste Station
Page 1
Thank you for your purchase! Compact Dog Waste Station ASSEMBLY INSTRUCTIONS Before You Begin: Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching during assembly.
Page 2
Congratulations! You just purchased a piece of happiness. At Ubique Group, we believe you can transform your spaces into the most inspired places with furnishings that are the perfect combination of form, function and style. As original innovators of online furniture retail, we offer the best selection of popular, contemporary styles at cool, comfortable prices.
Page 3
ASAP. But despite our best efforts, sometimes "slips happen." If you need any support, from replacement parts to recommendations, please reach out to our wonderful customer support team at 866-552- 2810 or customerexperience@theubiquegroup.com. We're here to help! EVERY UBIQUE GROUP PRODUCT Quality & Packaged Shipped from with Care our U.S.
Page 4
*50 mm Screws Box of Dog Waste M8 Spring Washer Bags M8 Flat Washer M8 Nut Roll of Can Liners Bag Dispenser *45 mm Screws Allen Wrench *12 mm Post Base Post Segment A Screws Trash Can M10*80mm Expansion bolt Wrench Bag Dispenser 1.
Page 5
STEP 1 Insert Post Segment A into the Post Base ensuring that the top welded plate (Zoom 1) is oriented towards the front of the station. Zoom 1 Align the 2 side holes from the Post Base with the 2 side holes from the Post segment A (Zoom 2).
Page 6
STEP 2 Place the Trash can face down. Take the entire post installed in Step 1 and line up the 3 holes on the back of the Trash can with the post holes marked in the image below. The foot of the Post Base must be oriented towards the front of the station. Insert (3) M8*45mm Screws and tighten using the Allen Wrench.
Page 7
STEP 5 Using a Hammer (Not Included) insert the M10*80mm Expansion Bolts into the holes as shown in the picture. Place the station foot over the screws and fasten in place using the (4) Flat Washers, Spring Washers and Nuts from the M10*80mm expansion bolt sets. STEP 6 To install the Can Liners, open the lid and pull the metal clamps upwards.
Page 8
STEP 7 Open the Bag dispenser to install the Dog Waste Bags. Unseal the boxes by removing the perforated section. Place the boxes as shown in the picture. For easier access, pull the bags a little bit out of the box. Close and lock the dispenser door.