Advertisement
Quick Links
Auto water changer
)
(Lite version
System connection -----------
Installation Notes
Instruction for A.T.O.
Instruction for A.W.C. --------
Buzzer and other functions ---
Meaning of beeps
Troubleshooting
Manual
Ver.1.0
P1
-----------
P2-3
--------
P4
P6
P8
----------
P10
----------
P11
Advertisement
Related Manuals for Smartreefs Tosta Lite
Summary of Contents for Smartreefs Tosta Lite
- Page 1 Manual Auto water changer (Lite version Ver.1.0 System connection ----------- Installation Notes ----------- P2-3 Instruction for A.T.O. -------- Instruction for A.W.C. -------- Buzzer and other functions --- Meaning of beeps ---------- Troubleshooting ----------...
- Page 2 Water level indicator Other possible connection: An anti-siphon · An anti-siphon device must be installed Appendix 1: Fresh water, using above the drainage pump, other wise non- Smartreefs water purifier as water source stop drainage may occur ; Function A.T.O. A.W.C.
- Page 3 Installation and A.T.O.function Installation of the host · The installation site must be cleaned before installation. Large algae or dirt may cause Installation 1. Install the host on the section where the abnormal sensing. steps water level in the fish tank can change, and make the current water level near the "LOW"...
- Page 4 · If the water level drops quickly after Features exceeding the HIGH level line, there may be Precautions A.T.O. introduction: It can automatically maintain A.T.O. water droplets remaining on the sensor the water level between the MID and LOW water head, which may cause a false alarm that the level to prevent the situation of low water level water level is too high.
- Page 5 3. Please press the AWC button shortly when the Setup 1. Press ATO and Pause simultaneously until Set Cycle A.W.C. A.W.C. water level drops to the expected position (this the system makes a beep. position must be lower than the LOW water level line, and it will be drained to this position every 2.
- Page 6 Buzzer "Drip": Buzzer alarm is enabled under Child lock 3. Press and hold the ATO and AWC buttons abnormal conditions. simultaneously for 5 seconds to release the "Didi": The beep alarm is not enabled under lock state. abnormal conditions. · The buzzer alarm will be triggered when the Level Buzzer "Dididi": The buzzer alarm is enabled under...
- Page 7 Beep meaning · Two continuous beeps after a long beep for 3 seconds: Replace the pump or solenoid valve · Alternate beep length: water change error, click any button to cancel. Troubleshooting suggestions A.T.O. fault · It is usually caused by water shortage or pump failure.
- Page 8 ** A physical safety device must be installed on the floor (lower ground) near the fish tank . Smartreefs · Please place the compression sponge on the front of the safety device, in the circular area under the physical switch, and then press the physical switch.
Need help?
Do you have a question about the Tosta Lite and is the answer not in the manual?
Questions and answers