Technical Data; Before Operation - BorMann BCD4040 Manual

EN

TECHNICAL DATA

Model BCD4040
Voltage 18 V
Guide bar 200 mm
Chain speed 4.2 m/s
Machine length 1.6-2.4 m
Oil tank capacity 60 ml
• Tool-free tension adjustment function
Other features • Auto-oiling function
• Detachable extension handle
Battery and charger not included

BEFORE OPERATION

Warning: Always remove the battery before making adjustments to the power tool.
Before each use, you must check the unit to ensure that:
• The safety devices and the cutting device are fitted and in perfect condition.
• All screws are securely fastened.
• All moving parts move smoothly.
• The equipment is not damaged in any way. Never use the power tool if it is damaged.
• There is sufficient oil in the oil tank.
• The chain is properly tensioned. For greater safety, you must check the chain tension at least every 10 minutes of operation.
• The teeth on the chain are sharp.
Filling the oil tank
Caution:
• Never operate the chain if it is not lubricated with chain oil. Use of the power tool without chain oil or with the oil level below the "min" mark will result
in damage to the unit.
• Make sure to fill the oil tank with chain oil that is of the appropriate viscosity, keeping in mind the ambient temperature conditions. The lower the
ambient temperature, the lower the viscosity should be. The higher the ambient temperature, the higher the viscosity should be.
1. Place the unit on an even surface.
2. Clean the area around the oil tank cap and remove the cap.
3. Fill the oil tank with chain oil. In the process, make sure that no dirt enters the tank.
4. Reinstall the oil tank cap.
Charging and fitting the battery (not included)
• Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the charger.
• Completely charge the battery with the battery charger before using for the first time.
• Once the battery is fully charged, fix the battery onto the power tool. Make sure that the battery is securely installed.
OPERATING INSTRUCTIONS
Switching ON
1. Hold the tool firmly with both hands.
2. Press the trigger lock and then press the ON/OFF trigger.
Switching OFF
Release the ON/OFF trigger.
Kickback
The term "kickback" describes what happens when the running pole chain saw suddenly kicks upward and backward. Usually this is caused by contact between
the tip or the upper part of the guide bar tip and the workpiece or by the chain becoming trapped. In the event of kickback, large forces occur suddenly and
violently. As a result, the power tool usually reacts uncontrollably. This can often result in very serious injuries to the operator or persons in the vicinity.
• Make sure that the chain tension is always correctly adjusted.
• Only use the power tool if is in perfect working order.
• Only work with a chain that has been properly sharpened in accordance with the instructions.
• Never cut with the tip or the upper part of the guide bar tip.
• Always hold the power tool firmly with both hands.
6
* The manufacturer reserves the right to make minor changes to product design and technical
specifications without prior notice unless these changes significantly affect the performance and
safety of the products. The parts described / illustrated in the pages of the manual that you hold in
your hands may also concern other models of the manufacturer's product line with similar features
and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection
or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided
equipment may cause malfunctions or even serious injury or death. The manufacturer and the
importer shall not be liable for injuries and damages resulting from the use of non-conforming
equipment.
WWW.NIKOLAOUTOOLS.GR