Advertisement
If the cabinet has been vertically placed during transport, please wait 2 hours
Connect the cabinet to a socket and turn on the
switch on the control panel, see Fig 1.0
Thermostat
The thermostat is placed in the control panel, see fig. 2.0.
The thermostat has been pre-set and in most cases it is not
necessary to adjust the settings.
When turning on the cabinet the display will show the current
temperature in the cabinet.
Display set temperature
Press and immediately release this key and the display will show the set temperature.
SET
Press the key again to return to normal reading.
Set new temperature:
SET
Press this key for more than 2 seconds and the display shows the set temperature.
Press this key for more than 2 seconds to increase the set temperature.
Press this key for more than 2 seconds to lower the set temperature.
Press this key for more than 2 seconds to save the new settings. The display will flash
SET
with the new value and will then return to normal reading.
Alarm codes
PF1—Flashing in the display: indicates that the cabinet sensor is defective. The cabinet will
strive to keep the set temperature until it has been repaired.
DISTRIBUTED BY:
Important!
before turning the cabinet on.
Fig 1.0
4
SOUTHERN
p: 0800 503 335 | w: www.southernhospitality.co.nz
HOSPITALITY
e: weborders@southernhospitality.co.nz
Fig 2.0
Advertisement
