Part Names And Functions; Front Panel; Rear Panel - Yamaha DCU5D Owner's Manual

Part Names and Functions

Front Panel

1 2
POWER

Rear Panel

AC IN 1P:GND 4P:12V
3 4 5
A
[POWER] Indicator
This indicator lights up when power is supplied to
the DCU5D.
NOTE:
This device does not have a power switch.
B
Mode switch
Use this mode switch to update the firmware in the
future. Do not press this switch if not necessary.
C
Ground screw
To ensure safe operation, be sure to ground the
DCU5D securely. The included power cord has a
three-prong plug that will ground the unit when
plugged into an appropriately grounded three-prong
type AC mains outlet. If the AC outlet is not
grounded, be sure to ground the unit by using this
ground screw.
D
[AC IN] connector
Connect the included power cord here. First,
connect the power cord to the DCU5D, then insert
the power cord plug into an AC outlet.
Be sure to use the included power cord.
Use of other cords may result in malfunction,
CAUTION
overheating, or fire.
E
[EXT DC INPUT] connector
This is an XLR-4-32-type connector for supplying
external power (+12V) to back up the DCU5D
internal power supply. For details, refer to page 22.
1
POWER
OUT
CASCADE IN
6
F
[CASCADE IN][CASCADE OUT] connectors
These are D-sub half-pitch 68-pin connectors that
connect the CASCADE connectors of the PM5D via
a dedicated cascade cable.
NOTE:
The DCU5D is a cabling unit exclusively for the PM5D
and the DSP5D. A Yamaha DME64N can be connected
only via the PM5D and the DSP5D.
G
[CASCADE IN][CASCADE OUT] connectors
These are RJ-45 connectors that connect the DSP5D
via an Ethernet CAT5 cable. See page 21 for system
examples, or refer to the PM5D Owner's Manual for
details.
NOTE:
• Use a CAT5 STP (Shielded Twisted Pair) cable to
prevent electromagnetic interference.
• These connectors use EtherSound technology, but can
not be connected to other EtherSound devices. They
are used exclusively for cascade connection of the
PM5D and the DSP5D. For more details on the length
of available cables, refer to the following website.
http://www.ethersound.com/technology/compatibility.php
H
IN/OUT[TX][RX] indicators
Each indicator blinks when [CASCADE IN]
[CASCADE OUT] connectors described in item
transmit (TX) / receive (RX) signals.
Accessories
• Owner's Manual
• AC power cord
Part Names and Functions
IN
OUT IN
TX RX TX RX
7 8
7
5