Skyrocket FACTION GEL BATTLE SYSTEM Quick Start Manual

GEL BATTLE SYSTEM
This blaster has been disabled
for safety and will not fire. It will
flash yellow/red until unlocked.
!
FOLLOW STEPS 1 THRU 3
TO UNLOCK & RE-ENABLE
YOUR BLASTER
INITIAL SET-UP
1
CHARGING YOUR BLASTER
Flashing RED
5V, 2A adapter
Recommended = charging
(Sold Separately)
2
DOWNLOAD THE
FACTION BATTLE APP
Scan or visit FactionBattle.com to download
and install the FREE Faction Battle System
app. Update your phone to its most current
operating system for best performance.
THE SPECTRE GEL BEAD BLASTER
LED LIGHT BAR
Light bar changes color
to display blaster status.
Lights may automatically
change during gameplay
when using the app.
SAFETY:
Lock firing mechanism when
not in use or charging.
PREPARING GEL BEADS
5,000
Beads
Pour
dehydrated
beads into
water. 1/2 GAL.
(2L)
Too little water may prevent beads from fully expanding and
cause jams, misfires and poor performance. If in doubt, add
more water.
SMART BEACON ASSEMBLY
Press to turn ON. Press again and
momentarily hold to turn OFF.
Refer to app set-up instructions for
use with app.
3x
Install
AAA (LR 03)
(Not Included)
QUICK START GUIDE
IT'S A BLAST! - WITH OR WITHOUT THE APP
Once unlocked, the Faction Spectre works like any other gel bead blaster. It will not require any further
connection to a phone or app to work. Just turn it on, load it up with gel bead ammo and blast away!
Connecting with the app is highly recommended however, as it will take your blasting game experience to
a whole new level. When connected to the app, certain blaster functions (such as Firing Mode selection,
LED lights, and the ability to fire) may be controlled by the app during gameplay. Full control may be
restored at any time by closing the app and powering your blaster on and off.
3
Plug charging cable into
blaster and charging port.
(Use included cable only)
Solid GREEN
= full charge
ON/OFF
Soak 3 hours for full hydration.
1
2
PAIR & UNLOCK YOUR BLASTER
THROUGH THE APP
Ensure phone's Bluetooth is on. Launch app, then turn
blaster on to initiate pairing. (If blaster is already on,
but not flashing blue, quickly turn off then on again to
re-initiate pairing). Follow in-app instructions to select
blaster. Blaster will pair, automatically unlock and be
ready for use. Once paired, blaster will auto-pair to your
phone whenever both the app is open and blaster is
turned on. Should pairing fail, turn blaster off then on
again and re-attempt connection.
NOTE:
Faction blasters ONLY connect through the app. Blaster will not appear in your
phone's Bluetooth settings. It can only connect when app is open and running and it will
automatically disconnect when app is closed.
You can pair a blaster to a different phone by following the same steps. Just be sure to close
app on original phone until blaster has successfully paired with alternative phone.
APP SUPPORTED FUNCTIONS REQUIRE PAIRING AND CELLULAR DATA.
CHAT and HIT buttons only function during
gameplay when used with the app.
CHAT BUTTON
Press and hold to talk with teammates.
Release to stop talking.
HIT BUTTON
Press during gameplay to indicate you've
been hit.
LOADING THE AMMO CLIP
Scoop beads and drain
water through fingers.
DO NOT ALLOW EXCESS WATER TO POUR INTO THE BLASTER AS THIS MAY DAMAGE
THE BLASTER. DO NOT OVER TIGHTEN THE CLIP.
PLAYING TARGET PRACTICE (WITHOUT APP)
Turn beacon on. Blast the beacon when it turns BLUE,
but don't blast it when the light turns off.
GREEN = Successful hit
SCAN FOR
INSTRUCTIONS
FIRING MODES
Single Fire:
1 shot per trigger pull
Burst Fire:
3 shots per trigger pull
Full Auto Fire:
Shoot continuously
until trigger is released
Pour beads into clip.
With blaster upside down,
Do not overfill. insert clip and turn to lock.
RED = Mis-hit after light turns off
Flashing BLUE
= pairing mode
2
1