Skyrocket FACTION GEL BATTLE SYSTEM Quick Start Manual

GEL BATTLE SYSTEM
This blaster has been
disabled for safety
and will not fire. It
!
will flash yellow/red
until unlocked.
FOLLOW STEPS 1 THRU 3
TO UNLOCK & RE-ENABLE
YOUR BLASTER
INITIAL SET-UP
1
CHARGING YOUR BLASTER
Flashing RED
5V, 2A adapter
= charging
Recommended
(Sold Separately)
2
DOWNLOAD THE FREE
FACTION BATTLE SYSTEM APP
Scan or visit FactionBattle.com to download
and install the FREE Faction Battle System
app. Update your phone to its most current
operating system for best performance.
THE HAVOC GEL BEAD BLASTER
LED LIGHT BARS
Light bars change color
to display blaster status.
Lights may be controlled
by game when connected
to the Faction app.
ACTION CAM MOUNT
CHAT BUTTON
Press and hold to talk with
teammates. Release to stop talking.
PREPARING GEL BEADS
5,000
Beads
1/2 GAL.
(2L)
Pour dehydrated Soak 3 hours
beads into water. for full hydration.
Too little water may prevent beads
from fully expanding and cause jams,
misfires and poor performance.
If in doubt, add more water.
QUICK START GUIDE
IT'S A BLAST! - WITH OR WITHOUT THE APP
Once unlocked, the Faction Havoc works like any other gel bead
blaster. It will not require any further connection to a phone or app to
work. Just turn it on, load it up with gel bead ammo and blast away!
Connecting with the app is highly recommended however, as it will
take your blasting game experience to a whole new level. When
connected to the app, certain blaster functions (such as Firing Mode
selection, LED lights, and the ability to fire) may be controlled by the
app during gameplay. Full control may be restored at any time by
closing the app and powering your blaster on and off.
3
Plug charging cable into
Ensure your phone's Bluetooth is on. Launch
blaster and charging port.
app, then turn blaster on to initiate pairing.
(Use included cable only)
(If blaster is already on, but not flashing blue,
quickly turn off then on again to re-initiate
pairing). Follow in-app instructions to select Faction
Havoc. Blaster will pair, automatically unlock and
Solid GREEN
be ready for use. Once paired, blaster will auto-pair
= full charge
to your phone whenever both the app is open and
blaster is turned on. Should pairing fail, turn blaster
off then on again and re-attempt connection.
NOTE:
appear in your phone's Bluetooth settings. It can only connect when app
is open and running and it will automatically disconnect when app is closed.
You can pair a blaster to a different phone by following the same steps.
Just be sure to close app on original phone until blaster has successfully
paired with new phone.
FLUORESCENT
OPTIC SIGHTS
MOTORIZED MOTORIZED
AMMO CLIP AMMO CLIP
AMMO CLIP RELEASE SWITCH
Slide forward to release and remove ammo clip
LOADING THE AMMO CLIP
Scoop beads and drain
water through fingers.
CLEAR BLASTER AND CLIP WHEN FINISHED:
jams next time you battle. After emptying ammo clip, reattach to blaster, turn blaster upside down, and
fire blaster until the feed tube in the ammo clip is clear of all beads.
PAIR & UNLOCK YOUR BLASTER
THROUGH THE APP
Faction blasters ONLY connect through the app. Blaster will not
APP SUPPORTED FUNCTIONS REQUIRE PAIRING AND CELLULAR DATA.
ON/OFF
HIT BUTTON
Press during gameplay to
indicate you've been hit.
Open flap at top of clip and
carefully fill with beads.
SCAN FOR
INSTRUCTIONS
Flashing BLUE
= pairing mode
FIRING MODES
CHAT and HIT
buttons only
Single Fire:
function during
1 shot per trigger pull
gameplay when
used with the
Burst Fire:
Faction app.
3 shots per trigger pull
Full Auto Fire:
Shoot continuously
until trigger is released
SAFETY:
Lock firing mechanism when
not in use or charging.
Slide ammo clip onto rail and push
upward, until locked into position.
Uncleared beads will dry, stick, and cause
One-time snap
together
assembly.
Faction-
Havoc-
Connecting