JMA Weather Protection System WPS-DF Installation Instructions

Installation Instructions
JMA Weather Protection System™
For 1/2" Connections to Antenna or Device
Materials (all sold separately)
WPS-DF
(for antenna)
RDCUTTER
Step 1: Install WPS-4A or WPS-4S and 1/2" connector
Prior to cable preparation, slide the
WPS-4A or WPS-4S onto the 1/2"
cable 6-12 inches from the end.
Step 2: Cut WPS-DF
Measure the WPS-DF from the end
of the port to the beginning of the
threads as shown. Use your thumb to
mark a cut line.
©2023 JMA Wireless. All rights reserved. This document contains proprietary and confidential information. All products, company names,
brands, and logos are trademarks™ or registered® trademarks of their respective holders. All specifications are subject to change without
notice. Revised: January 17, 2024 +1 315.431.7100
WPS-4A or WPS-4S
(for connectors)
TQ-114-F18 torque wrench
Prep the 1/2" cable to install the JMA
compression connector. Refer to the
appropriate 1/2" connector installation
instructions.
Align the blade of the RDCUTTER to the
thumb mark indicating the cut length.
Using one firm cutting motion, cut the
WPS-DF to the proper length.
customerservice@jmawireless.com
JMA 1/2" DM connector
Properly measured WPS-DF.
12812-01 rev. D
Page 1