Page 11
ELEX K2 (Hohner Stringvox) (r3) K2-1 Voicing Board: Drawing designed c.1975 ELEX S.p.A. (Excelsior) drawn 2024 electropict C7 + + C8 R14 R15 R16 R14 R15 R16 The board is drawn from components side, semi-transparent to show the There are twenty versions of the board each with varying resistor and circuit side.
Page 14
ELEX K2 (Hohner Stringvox) (r3) K2-2 ‘Matrix’ Board: Schematic designed c.1975 ELEX S.p.A. (Excelsior) drawn 2024 electropict bass range treble range b a61 solder teminals for wires to K2-3 ⓐ 1 1 ⓐ piano sustain (off = grounded) 0R56 +1 5...
Page 15
K2 Divider Pitch Outputs Dividers Pins Dividers are numbered left to right. Only output pins are shown. Outputs are shown as IPN pitches. B 0 and E 1 are not used. This table does not include the top octave F#6–F7 which is produced by the TOG chip on OS-5.
Page 25
ELEX K2 (Hohner Stringvox) (r3) K2-20-2 Modulation Board: Drawing design c.1975–79 ELEX S.p.A. (Excelsior) | drawn 2024 electropict C8 C9 C10 C8 C9 C10 audio audio modulation Shown from components side transparent to solder side. The K2-20-2 takes an input audio signal and delays it using the TCA350Z BBD chip, by amounts controlled by the incoming modulation signal from the M174 Oscillator board.
Need help?
Do you have a question about the StringVox K2 and is the answer not in the manual?
Questions and answers