senva IOT Buddy Installation Instructions

INSTALLATION INSTRUCTIONS
IOT Buddy
Power Over Ethernet (POE), Ethernet,
or Wireless 2.4 GHz
PRODUCT APPLICATION LIMITATION:
Senva products are not designed to be used as the lone device for life or safety
applications. Senva products are not intended for use in critical applications
such as nuclear facilities, human implantable device or life support. Senva
believes a systems approach to safety is necessary for these types of applica-
tions. Senva is not liable, in whole or in part, for any claims or damages arising
from such uses.

DIMENSIONS

POE
28.45 mm 26 mm
WiFi
22.5 mm
20.88 mm
Ethernet
22.5 mm 26 mm
62 mm
Not to Scale
44 mm
www.senvainc.com 1-866-660-8864 Fax: 1-503-296-2529 1825 NW 167th PL Beaverton OR 97006

INSTALLATION

1.Wire device per the wiring diagrams (See Page 2).
2. Once powered, the wireless IoTBuddy will host an access
point for 5 minutes. To re-enable the access point, press the
button on the IOTBuddy.
To connect using the wireless IOT Buddy QR Code:
If you are setting up the device with a smart phone, scan device
QR code to access the access point to set up the device. The
user interface guide can be access by scanning the QR code
below.
To manually connect to the wireless IOT Buddy:
1.Open your Wi-Fi network page and find the IOTBuddy access
point that matches the serial number printed on your IoTBuddy
label. Connect using the Password: password
2. Go to https://4.3.2.1, then follow steps 3-4 of the next section.
To connect to the web interface of the IOT Buddy:
1. Determine the IP Address of the IOT Buddy and connect to
the same network. The Senva Sync App can be used to retrieve
or set the IP Configuration.
See the user interface guide for help with network setup and
the Senva Sync App. (visit www.senvainc.com
code below).
2. In a browser, navigate to https://
3. Your browser may indicate a non-private connection. Find
the "proceed" button near the bottom of the warnings; click the
link labeled "advanced" or "show more".
4. Log in using the default credentials:
Username: admin Password: admin

LED STATUS/INDICATION

Normal Mode:
Off=Not Configured
Steady= No Connection
Slow Blink = Connected to device
Fast Blink= Connected to cloud service
Setup Mode:
Off=Button Held (Hold for 3 seconds)
Slow Blink = Commissioning Mode
Fast Blink= Hold to Initiate Factory Reset
IMPORTANT!

IMPORTANT WARNINGS

• Only qualified trade installers should install this product
• This product is not intended for life-safety applications
• Do not install in hazardous or classified locations
• The installer is responsible for all applicable codes
• De-energize power supply prior to installation or service
or scan the QR
and the IP address assigned.