Download Print this page

LapCabby V Series Instructions Manual page 5

Laptop charging & storage units

Advertisement

Sequence Time
Pressing either "One" or "Two" the sequence time is displayed
Pressing the right hand "+" button or the left hand "-" button will enable the sequence time to be changed from any time between 10 mins and
60 mins e.g. 20 mins – the default is 15 mins
Pressing the centre button or waiting approximately 10seconds completes the set up.
All other Power 7 settings e.g. Setting the Time and Date and Charging Modes are as per the standard Power 7 instructions that come with the
Lapcabby unit.
Maximum Continuous Load
The maximum acceptable total continuous loadings are as follows:
Region
UK
Europe
North America
In North America the maximum load on a single socket is 1440 watts (120V x 10amps).
Many tablets and laptops require between 20 watts and 45 watts, however newer devices may require more power.
The Power 7 on a LapCabby or UniCabby unit defaults to cyclical charging when it detects a 110V/120V supply. This means that
one power strip is off while the others charge with the 'off' strip rotating every 15 minutes. This adds 25% to the charge time
but also reduces the load on the socket by 25%.
If you have a 36V unit, with 36 laptops that require 45 watts each this requires 36 devices x 45 watts = 1620 watts required
In this scenario the total requirement of the devices is over the maximum load available from the socket.
You must leave the device in cyclical mode, charging only 27 devices at a time, 27 devices x 45 watts = 1215 watts required
If you have a 36V unit, with 36 laptops that require 30 watts each this requires 36 devices x 30 watts = 1080 watts required
In this scenario the total requirement of the devices is under the maximum load available from the socket.
You have the option to disable cyclical charging following the instructions above.
It is the end users responsibility to calculate and verify the maximum requirement of their devices before switching off cyclical
charging.
If cyclical charging is disabled and the Power 7, devices, or electrical supply are damaged due to overload this will not be
covered by the warranty.
Supply
230V 50Hz
230V 50Hz
120V 60 Hz
Charging Speed
Max Continuous Load/Sequence
None
2880W
3840W
2760W
3680W
1440W
1920W
100%
Page 4
One
Two
5760W
5520W
2880W
75%
50%

Advertisement

loading

This manual is also suitable for:

H seriesMini series10v16vc20v32v ... Show all