2.5
Hardware Assembly
This section details the hardware assembly steps for the BOXER-6711-ADN. Please read
this section thoroughly before beginning installation and ensure you have all necessary
peripheral hardware ready.
2.5.1
2.5" SATA Drive Installation
Before installing the SATA Drive, ensure the system is powered down and disconnect
the power cord from the system. Make sure you have the SATA Drive ready to install.
Step 1: Remove the six (6) screws from the bottom of the chassis to remove the bottom
panel from the system. Then attach the SATA drive to the HDD Bracket using the four
(4) screws provided.
Chapter 2 – Hardware Information
31