Download Print this page

BOMANN GSPE 774.1 Instruction Manual page 27

Advertisement

Positioning the Appliance
Position the applianc e in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets o r wa lls. T he dishwasher is equipped with water supply and drain hoses th at can
be positioned either to the righ t or the left sides to facilitate proper installation.
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cann ot be drained dire ctly
into the sink. It will be necessary to drain excess water from hoses into a bo wl o r suitable
container that is held outside and lower th an the sink.
Water Outlet
Connect the water drain hose. The drain hose mu st be correctly fitted to avoid water leaks.
Ensure that the water dra in hose is no t kin ked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced .
Syphon Connection
The waste connection must be at a he ight of between 40 cm (minimum) and 100 cm (ma ximum)
from the bottom of the dish. T he water drain ho se should b e fixed by a hose clip. The free end of
the hose must not be immersed in water.
The following things should be checked before starting the dishwasher.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is not a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are not knotted
7
All packing materials and printings should be taken out from the dishwasher
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time , let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water in let to be blocked and damage the a ppliance.
Please close the hydrant after using.
23

Advertisement

loading