Table of Contents
Advertisement
Quick Links
©2023 FarmTek®
All Rights Reserved. Reproduction
is prohibited without permission.
Revision date: 03.01.23
Sunblocker Shade House
24' Wide
Photo may show a different but similar model.
CANOPIES
STK#
DIMENSIONS
2420SPC
24' W x 20' L
2430SPC
24' W x 30' L
2440SPC
24' W x 40' L
2450SPC
24' W x 50' L
2460SPC
24' W x 60' L
1
Advertisement
Table of Contents
Related Manuals for FarmTek 2420SPC
Summary of Contents for FarmTek 2420SPC
- Page 1 CANOPIES Sunblocker Shade House 24' Wide Photo may show a different but similar model. STK# DIMENSIONS 2420SPC 24’ W x 20’ L ©2023 FarmTek® 2430SPC 24’ W x 30’ L All Rights Reserved. Reproduction 2440SPC 24’ W x 40’ L is prohibited without permission.
-
Page 2: Safety Precautions
BEGIN TO ASSEMBLE THE SHELTER. • Never erect the structure under power lines. Thank you for purchasing this FarmTek® shelter. When • Identify whether underground cables and pipes are properly assembled and maintained, this product will present before preparing the site or anchoring the provide years of reliable service. -
Page 3: Assembly Procedure
These words and phrases are common to most joints and to fasten brackets to rafters. FarmTek® shelters and identify the different parts of the shelter. (Some are used in this document. Others may not apply to this particular shelter.) These terms describe the shipped parts and can also be found on the materials list/spec sheets included with the shipment. -
Page 4: Required Tools
CANOPIES REQUIRED TOOLS ALTERNATIVE ASSEMBLY INFORMATION The following list identifies the main tools needed to These instructions describe assembling the entire roof assemble the shelter. Additional tools and supports may be section of the shelter first. The frame is then lifted and the needed depending on the structure, location, and legs added. - Page 5 CANOPIES The following graphics and photos will help you identify the different parts and show you how they are used. (Some parts are not shown.) QH1402 FA4482B Band Clamp Tek screw QH1308 CC4595 7' Strut Tie Down 8'' Snugger Ball Plain Swaged Swaged and Plain Rafter Sections...
- Page 6 CANOPIES ADDITIONAL PARTS IDENTIFICATION NOTES In some instances, there can be differences between the parts that are shown and referenced in the instructions and the parts that are shipped with the shelter. These differences do not affect the integrity of the shelter, but can change the assembly procedures.
- Page 7 CANOPIES Sunblocker Shade House OVERVIEW This section describes assembling your shelter. For details of each assembly procedure, consult the Frame Overview and the individual sections of these instructions. See illustration below to identify main parts of shelter. 1. Layout the site and identify the required parts for each assembly procedure.
-
Page 8: Frame Assembly
CANOPIES LAY OUT THE BUILDING SITE Frame Assembly Procedure After the site is prepared, identify the location of the shelter corners to help square the frame after it is assembled. Arrange the roof pipes on the ground adjacent to the correct couplers needed to assemble the roof. - Page 9 CANOPIES FRAME ASSEMBLY (CONTINUED) SQUARE THE ASSEMBLED FRAME Gather the parts: 4. Add horizontal struts (#QH1308) between rafter pipes at each rafter. Secure at each end using a band clamp • Measuring tape and assistants as shown below. Complete these steps: 1.
- Page 10 CANOPIES INSTALL THE MAIN COVER After assembling the main frame, install the main frame cover. Gather the parts: • Snugger ball tie downs (#CC4595) • Main cover and side panels (if equipped) NOTE: Assistance is required to assemble the shelter. 1.
-
Page 11: Care And Maintenance
Never pack the covers when they are wet. Always dry them before you pack the shelter. • For replacement or missing parts, call 1-800-245-9881 for assistance. NOTE: With the exception of Truss Arch buildings, FarmTek® shelters and greenhouses do not have any tested loading criteria. Revision date: 03.01.23... - Page 12 CANOPIES 13'-1 15/16" Height 6'-5" QUICK START GUIDE Endwall Height 24' Wide Sunblocker Shade House 22'-10 11/16" Width F F R R O O N N T T Grid Represents 12" Squares NOTE: Actual frame may differ from frame shown. Revision date: 03.01.23...
- Page 13 CANOPIES Revision date: 03.01.23...
- Page 14 CANOPIES Revision date: 03.01.23...
- Page 15 CANOPIES Revision date: 03.01.23...
- Page 16 CANOPIES Revision date: 03.01.23...
- Page 17 CANOPIES Revision date: 03.01.23...
- Page 18 CANOPIES Revision date: 03.01.23...
- Page 19 CANOPIES Revision date: 03.01.23...