Yamaha NS-E105 User Manual

Thank you for selecting this Yamaha NS-E105
speaker system.
This model is designed to be used as an effect
speaker in a Cinema DSP/Surround Sound system.
PRECAUTIONS
Read these precautions carefully before using your
speaker.
● Any time you note distortion, reduce the volume
control on your amplifier to a lower setting. Never
allow your amplifier to be driven into "clipping".
Otherwise the speaker may be damaged.
● When using an amplifier with a rated output power
higher than the nominal input power of the speaker,
care should be taken never to exceed the speaker's
maximum input.
● Do not attempt to clean the speaker with chemical
solvents as this might damage the finish. To clean,
wipe with a dry, soft cloth.
● To prevent the enclosure from warping or discolor-
ing, do not place the speaker where it will be
exposed to direct sunlight or excessive humidity.
● Do not place the speaker where it is liable to be
knocked over or struck by falling objects. Stable
placement will also ensure better sound perfor-
mance.
● Placing the speaker on the same shelf or rack as
the turntable can result in feedback.
● As these speakers contain strong magnets, avoid
placing watches, magnetic tapes, etc. near them.
Also, placing the speakers near a TV set may impair
picture color. If this happens, move the TV set away
from the speakers.
● Secure placement or installation is the owner's
responsibility. YAMAHA shall not be liable for
any accident caused by improper placement or
installation of the speaker.
NS-E105
CONNECTION TO
YOUR AMPLIFIER
BEFORE MAKING CONNECTIONS, MAKE SURE
THAT THE AMPLIFIER IS SWITCHED OFF.
CONNECTIONS
● Connect the push-type input terminals at the rear of
the speakers to the speaker output terminals of
your amplifier with the provided speaker cables.
● One side of the speaker cable is marked by a blue
line. Connect the (+) terminals on both the amplifier
and the speakers using this blue-marked side.
Connect the (–) terminals on both components
using the unmarked side of the cable.
● Connect one speaker to the left (marked L) termi-
nals of your amplifier, and another speaker to the
right (marked R) terminals, making sure not to
reverse the polarity (+, –). If one speaker is con-
nected with reversed polarity, the sound will be
unnatural and lack bass.
Procedures:
Press the tab on the terminal down, as shown in
the figure.
Insert the bare wire end properly into the terminal
hole. [Remove approx. 5 mm (1/4") insulation
from the speaker cable.
Remove your finger from the tab to allow it to lock
snugly on the cable's wire end.
Test the security of the connection by tugging
lightly on the cable at the terminal.
Natural Sound Bass-Reflex
Effect Speaker System
Speaker (R)
Blue line
Blue line Blue line
R L
Speaker output
terminals of the
amplifier
Note
Do not let the bare speaker wires touch each
other as this could damage the speaker and/or
the amplifier.
Press tab
Speaker (L)