Advertisement
The furnace body (heat exchanger 15) is made of
die-casting aluminum, with radiating fins around and
at the rear end. Combustion pipe 22 （ include
12-Pipe base 13-Guide pipe）is installed in the inner
cavity. The combustor core 20(include 19-Fuel pipe)
with a protective hood is fixed on the front-end base
12 of the combustion pipe. Fuel comes to the
combustor core through the fuel pipe 19 and is
ignited by the glow plug 11 (also serves as flame
sensor) after atomization. The flame enters the gap between
the inner walls of the furnace body through the rear-end
guide pipe 13 of the combustion pipe. The exhaust is
discharged through exhaust pipe vent 23.
The fresh air for supporting combustion of the furnace comes from the
supporting air inlet port 17 and is sent to the combustion pipe by the combustion
supporting air blades 18 of the fan motor.
Burner is quick-wear
part which should be
replaced after every
800 hours
1-Controller 2-Screw 3-Overheat sensor 4- O-ring 5- Heat exchanger
6- Fan motor assembly (includes combustion supporting fan blades and blade
wheel of heating fan) 7-Screw 8- Seal of heat exchanger 9-Screw
10-Screw 11-Glow plug/Flame sensor 12-Pipe base 13-Guide pipe
14- Inlet of combustion supporting air 15- Blade wheel of heating fan
16-Fuel inlet pipe 17- Combustor core 18- Screw 19- Combustion pipe
20- Exhaust pipe vent
21- Insulating mat
2
1-Combustion furnace;
Fig.3
Fig. 2
2-Hood-shape case;
3-Controller;
4-Insulating mat;
Advertisement
