Veracity LONGSPAN LITE VLS-1N-L Quick Start Manual

LONG RANGE ETHERNET

12V DC POWER
POWER
SUPPLY
POWER
LONGSPAN LINK

LONGSPAN LITE CAPABILITIES

| LONGSPAN Lite can deliver an unrestricted
full-duplex 100Base-TX connection
up to 820m on Cat6 or up to 600m on
Cat5e network cable.
| A 10Base-T connection can be
achieved up to 1050m on Cat6. See
LONGSPAN Lite datasheet for details.

POWER INPUT

| LONGSPAN Lite must be powered
externally (i.e. not via POE).
| LONGSPAN Lite is normally powered by
a 12V DC source but can accept a
wide range of power inputs: 8V-57V DC
or 20V-28V AC.

INSTALLATION NOTES

|
Standard Cat5e or Cat6 cable and
RJ45 connectors should be used.
| LONGSPAN Lite supports both patch
and crossover cables. Patch wiring
(straight through connection) is
recommended.
|
LONGSPAN devices may also be used
with other twisted pair cables*
as follows:
4-pair cable: 10Base-T /100Base-TX with
standard Cat5e / Cat6 pin-out.
2-pair cable: 100Base-TX performance
can be achieved on 2 pairs, where pins
1 & 2 are used for data and pins 7 & 8
are used for POE.
1-pair cable: 10Base-T/100Base-TX
performance can be achieved on 1pair,
where pins 1 & 2 are not crossed-over.
|
When connecting LONGSPAN devices
on cables over 600m or over cables
with four or more joins (couplers, outlets,
patch panels) on-site testing is
recommended.
VPSU-12V-U
(LOW VOLTAGE 12V DC)
POWER
SUPPLY
POWER
KEY
1 2
VLS-1N-L
100BASE-TX
®
1
ETHERNET DATA ONLY
VLS-1N-L
UP TO 820M ON CAT6
1
LITE
DATA ONLY POWER OVER ETHERNET
3 Surge Protection DEVICES RECOMMENDED FOR LONG OUTDOOR NETWORKS
QUICKSTART GUIDE
LONG
820M ON CAT6
LONGSPAN LINK
1 2 3 SURGE PROTECTION
|
LONGSPAN Lite is fully self-configuring,
featuring remote diagnostic LEDs
and an extended temperature rating
-40ºC to 70ºC.
|
Please observe the correct polarity on
the green 2-pin screw terminal connector
when using DC power sources.
|
The correct polarity is shown on the
product top label.
| LONGSPAN Lite extended network link
setup and configuration is fully automatic.
| LONGSPAN Lite Ethernet ports should
be connected to 100Base-TX or 10Base-T
Ethernet compatible equipment.
| LONGSPAN Lite extended network
ports should only be connected to other
LONGSPAN extended network ports.
Devices are always used in pairs.
|
LONGSPAN Lite is data-compatible
with LONGSPAN Base & Camera devices
(POE models) but does not accept or
transmit POE.
|
Please refer to your regional Veracity
Technical Support team for help & advice.
*Stated performance will be achieved where
twists/metre and cable length permits,
otherwise LONGSPAN will default to
10Base-T performance.
POWER
SUPPLY
(RECOMMENDED
56/57V DC PSU
FOR MAX POWER)
2
LONGSPAN LINK
LONGSPAN LINK
VLS-1N-L
L O N G R A N G E E T H E R N E T
SPAN
LITE
VLS-1N-L
3
®
2
POWER
SUPPLY
VLS-LSM-C4
3
3
MAX QUAD
3
3
ETHERNET & HI-POE
®