How To Playback A Song - Yamaha PortaSound PSS-590 Owner's Manual

>> Simultaneous Recording on Both
MELODY and CHORD Tracks:
When you record the melody and accompaniment at a
time, as explained in Step 3, set both MELODY and
CHORD Tracks in the STAND BY position by pressing both
REC buttons. Then follow Steps 4 and 5 as normally. At
this time, play Auto Accompaniment keys (lower than G2)
by the left hand, and melodies should be played with higher
keys than F#2.
>> Re-recording Methods:
In case you have mistaken and Re-record it, just repeat
Steps 2 thru 5 as many times you wish. Every time you
Re-record, an old performance will be overwritten by a
newly recorded one. Why don't you take the best one?
»» When you want to record another Song,
choose another Song number as explained in Step 1, and
then continue Recording following Steps 2 thru 5.
*
Once you start the song to Record or Playback, you cannot set the
other Track in RECORD position during the song running.
* During Recording, if the capacity of Song Memory has been reached,
the following indication will be shown for a second and the Recording
will automatically stop.
Crores
CLD
AUTO ACCOMP, BEAT
In case this indication is shown while Recording on the MELODY Track,
even if you try a Re-recording on the MELODY Track by pressing the
keys, you cannot start it right away. Also, when Playback, you will hear
the beginning part of the Song incorrectly. When you Record on the
MELODY Track after «Ch Full» indication, first make a dummy Recording
or Clear the Song (for Clearing see page 27). Then start Re-recording.
* The contents of SONG MEMORY will be Stored even after you turn
OFF the POWER, if you have batteries installed.
CAUTION!!
Pay special attention when handling the
Song Memory.
The Song Memory data (= Songs you have = are
so delicate that will be easily destroyed by the electrical
shock. Actually, the data will be lost completely. Remember |
this will definitely take place in the following situations:
The Song Memory data will be lost completely when the
PSS-590 is turned Off intentionally or accidentally, that is,
by using the POWER switch, or with batteries' voltage
lowered or the authorized AC adaptor disconnected;
* immediately after the PSS-590 is turned On
* During Selecting a Song
* During Recording or Playback
26
d. How to Playback a Song |
Step 1: Select a Song number.
First, choose the Song number which you want to Playback !
by pressing the <+/-> buttons as explained in the Recording
procedure. |
* When you listen to the Playback of a Song you have just recorded, this |
operation can be skipped. |
í
Step 2: Start Playback.
When you press the PLAY/STOP button, the Recorded
performance will be Played Back. You can determine
which Track to Playback or not by pressing the
corresponding REC button (LED indication: available; ON,
inavailable; OFF) DURING Playback. If you turn OFF the
LED of either Track, the Playback will stop immediately.
Step 3: Stop Playback. N
When you reach the end of the Song, Playback will Stop
automatically. Also, you can Stop the Playback at any time,
by pressing the PLAY/STOP button.