Safety Precautions - Atari 800XL Technical Service Data

SAFETY PRECAUTIONS
1. Use an isolation transformer for servicing.
2. Maintain AC line voltage at rated input.
3. Remove power from the Computer before servicing or installing electrostatically sensitive devices. Examples of typical
ES devices are integrated circuits and semiconductor "chip" components.
4. Use extreme caution when handling the printed circuit boards. Some semiconductor devices can be damaged easily by
static electricity. Drain off any electrostatic charge on your body by touching a known earth ground. Wear a commercial¬
ly available discharging wrist strap device. This should be removed prior to applying power to the unit under test.
5. Use a grounded-tip, low voltage soldering iron.
6. Use an isolation (times 10) probe on scope.
7. Do not remove or install boards, floppy disk drives, printers, or other peripherals with power On.
8. Do not use freon-propelied sprays. These can generate electrical charges sufficient to damage semiconductor devices.
9. The Computer cabinet is equipped with vents to prevent heat build-up. Never block, cover, or obstruct these vents.
10. Instructions should be given, especially to children, that objects should not be dropped or pushed into the vents of the
cabinet. This could cause shock or equipment damage.
11- Never expose the Computer to water. If exposed to water, turn the unit Off. Do not place the Computer near possible
water sources.
12. Never leave the Computer unattended or plugged Into the AC outlet for long periods of time. Remove AC plug from AC
outlet during lightning storms.
13. Never use liquids or aerosols directly on the Computer. Spray on cloth and then apply to the Computer cabinet. Make
sure the Computer is disconnected from the power line.