Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Green Transporter Q Runner
Summary of Contents for Green Transporter Q Runner
- Page 1 Green Transporter Q Runner...
- Page 2 二、Part of the vehicle map and instructions for use 2. 2 Picture of the vehicle on the right left 2.1 The body part of an electric positive tricycle Structural sketch Structural sketch The picture is for reference only, the concrete item is based on the real thing The picture is for reference only, the concrete item is based on the real thing Component name Component name...
-
Page 3: Ignition Switch
2.3 Gauges and indicator lights 2.5 Ignition switch (1) Off (“OFF”)-when the switch is turned to this position, the power will be (1) Left and right turn indicator : the Left and right turn indicator flashes when turned OFF and the car keys can be pulled out. the turn signal button is pressed. - Page 4 2. 10 A dimming switch (figure 4 the ⑧⑨) 2.16 Safety Lock Button in the” ” position, high-beam light; Close the door with the key to prevent it from opening from the Button in the” ” position, low-light light; outside. 2.11 Parking lock (hydraulic parking) Car Lock : After the switch is closed, hold the front and rear brake handle tightly and press the parking button.
-
Page 5: Security Alert
3.4 Driving operation Check before use 1、 before starting the preparation: The car parking lock opened, to ensure that the Before using a motorcycle, be sure to check the following items Table 1 power switch in the state of the diagram, the key into the ignition switch, rotating to Projects Check content the“ON”... -
Page 6: Battery Wiring
Cable positive Security alert Cable negative 1. The Q Runner should be parked on a hard, flat road. It should not be parked on soft or sloping ground in case of accidents such as injury, vehicle toppling, rolling and so on. - Page 7 Charger 五、Maintenance and repair When charging, first connect the output plug of the charger with the charging 5.1 Storage Battery socket of the batter y, then connect the input plug of the charger to an AC power supply of 220V. The Red light on the charger indicates normal connection with the 5.1 Upkeep power supply.
- Page 8 Simple troubleshooting (table 1) Security alert (一）Power supply and braking To ensure the safety of personnel, no matter what the maintenance operation, must first turn off the power, the car Failure Processing method Reason parked on a flat hard ground and fixed. phenomenon T h e k e y s w i t c h i s i n Select the key to the“No”...
- Page 9 (二）Suspension and steering system (三）Electronic Control System （ Table 1） （ Table 1） Failure Failure Processing method Reason Reason Processing method phenomenon phenomenon Uneven wear of Inflate to recommended air The key switch shorted out Repair or replacement The tire pressure is too low tyres pressure Turn on the key...
- Page 10 In addition, in preparation for storage, also need to carry out some repair work, otherwise, once the use of the Q Runner, often Do not remove the top cover of the sealed storage battery solution.
- Page 11 八、Key technical data 九、After-sales service 一、General Provisions Thank you for buying our electric motorcycle. In order to protect your legitimate rights Projects Specification parameter and interests, and to facilitate us to fulfill our three-pack obligations and responsibilities, please keep your warranty card properly. With the card and purchase invoices to the car Vehicle Identification Code (VIN first 8 digits) HW1KCU20 sales unit and our local service station to enjoy three packages of service.
-
Page 12: Electrical Schematics
Electrical schematics...
Need help?
Do you have a question about the Q Runner and is the answer not in the manual?
Questions and answers