Precor P94 Installation Manual

P94 (22") and P84 (16") Touchscreen Consoles
Installation Guide
WARNING Before you connect any cables to the console, make sure that
the equipment is not connected to any external power source.
Precor recommends at least two people for this installation. DO NOT
attempt assembly by yourself.
Before you begin
Match the correct number of paddles on the touchscreen to the appropriate lower equipment.
• Single paddle touchscreens = Upright Bike, Recumbent Bike, and StairClimber.
• Dual paddle touchscreens = Treadmill, Adaptive Motion Trainers (AMT), and Elliptical (EFX).
Install console cradle and display
1. Ensure all cables feed up through the console mount on the lower equipment.
NOTE (JAPAN ONLY) If using a tuner, install the BCAS card into the lower brackets of the monitor before seating the monitor on the cradle (Figure 5).
2. Place the cradle over and onto the console mount (Figure 1) and feed cables upward. Ensure cables are not pinched. Pinched or damaged cables during install are not covered
under warranty.
3. Gently seat the monitor into the cradle so it rests against the upper frame (Figure 2).
4. Set the monitor onto the cradle frame and secure with the four fasteners that came with the console (Figure 3).
5. Secure the console to the lower frame with the four fasteners from the lower.
Figure 1
Connect cables
Connect the cables that are appropriate for your configuration set up. Not all connections are used.
NOTE Before your begin, plug the CPA to MPA cable to the display
Make the connections in the order below.
Connection Type
1 1
BCAS Card (Japan Only)
2 2
Power
3 3 Set top box/media (used with HDMI-2)
4 4
Safety key stop (Treadmill only)
5 5
Manual stop (Stairclimber only)
6 6
Tuner power
7 7
Heart rate sensor
8 8
Lower LPCA
9 9
Handle controls (Stairclimber only)
10 10
MPA to CPA
11 11
TV, coaxial cable
12 12
Chromecast cable (optional)
13 13
CPA to MPA
14 14
Ethernet/network
15 15
USB-C (from cradle)
16 16
Audio
17 17
HDMI-1 to tuner/lower cradle
18 18
HDMI-2 to set top box/media
19 19
HDMI-3 to Chromecast (optional)
20 20
PrecorCast puck holder 1
21 21
PrecorCast puck holder 2
22 22
Headphone jack
23 23
USB-C port
24 24
Display reset button
25 25
Console reset button
©2023 Peloton Interactive | P94 P84 Touchscreen Console | Installation Guide
Figure 3
Figure 2
13 13 and unplug it from the cradle
24 24
13 13
10 10
25 25
4 4
3 3
2 2
22 22
Figure 4
10 10 . This will allow better access for the other connection points.
17 17 18 18
16 16
14 14
12 12
15 15
21 21
9 9 8 8
7 7
6 6
5 5
1 1
23 23
Figure 5
19 19
20 20
11 11
September 2023 | XXXXXXXXX-Xxx ENU | 1