NEC MultiSync 3D JC-1404HME Service Manual page 12

As for model JC-1404HMED
Screw "b" Plate, Shielding ASSY
Shield Case Screw "c"
4'. Remove the four screws "b" of the plate,
shielding ASSY and remove the plate,
shielding ASSY.
Remove the four screws "b" of the shield
case and remove the shield case.
5'. Remove the two screws "c".
Remove the five screws "b" of the SUB PWB
UNIT and the screw "b" (under the shield
Screw "d" case).
6'. Disconnect the connectors "CN-A", "CN-M"
and '·CN-S" (from SUB PWB UNIT).
Disconnect the connectors "CN-V" (from
CRT PWB ASSY) and lift up the SUB PWB
UNIT.
Band 7'. Remove the two screws "c".
Screw "b"
Screw "b"
Pawl
-11 -
Remove the two screws "d".
Remove the two screws "b" of the SW.
REG. UNIT and the two screws "b" (under
the shield case).
8'. Disconnect the connector "CN-K" (from
MAIN PWB ASSY).
Cut the band and disconnect the connectors
"CN-SW" and "CN-Z" (from SW. REG.
UNIT).
Lift up the SW. REG. UNIT.
:.,, ,,.
i,
•,,,r:, ,,·.