Sony TC-K850ES Operating Instructions Manual page 4

Installation
Notes on installation
¢ Place the unit in a location with adequate air
circulation to prevent internal heat build-up in the
unit.
Do not place the unit on a soft surface, such as a
rug, that would block the ventilation holes on the
bottom.
Install the unit with the front panel facing toward
you.
Do not install the unit:
—near heat sources such as radiators or air ducts.
—in a place subject to direct sunlight, excessive
dust, mechanical vibration or shock.
—in an inclined position.
Connections
¢ Connecting a CD player or a DAT deck to the CD
direct input terminal allows the sound signal of the
connected unit to be directly input to the unit. Since
this shortens the signal path, the result is higher
sound quality. However, due to the shortened signal
path, the BALANCE knob and MPxX filter are
rendered inoperative during input from the CD direct
input terminal. If your CD player is equipped with
two sets of output terminals, connect one set to the
amplifier and the other to the CD direct input
terminal of this unit. You may then use the INPUT
button to switch between CD direct input or line
input to suit your recording needs.
¢ Turn off the power to all equipment before making
any connection.
* Note that the red plug of the supplied connecting
cord is for right-channel (R) connection and the white
plug for left-channel (L) connection.
* The connecting cords should be fully inserted into
the jacks. A loose connection may cause hum
pickup.
Basic Connection
CD player
4
i
[oo
<> Signal flow
i]
= to an AC
outlet
TC-K850ES
LINE IN
to an AC outjet
Amplifier
=} to a wall
outiet
ni emelens TAPE INPUT
Connection for Tape Dubbing
LINE IN LINE OUT
to a wall outlet
<— Signal flow
li from another
tape deck
to another
tape deck |
Another tape deck
LINE IN LINE OUT