Table of Contents
Advertisement
By connecting the camera to another VCR, you can
edit your recordings in order to remove unwanted
Basic editing
scenes — or combine difterent shots to create your
Preparations
Before editing
own video production
After editing
1. Connect the camera to the VCR.
• See "Playback Connection" on p. 14,
2. Turn the TV on.
• Be sure to set it to the video channel, or set
the TV/VIDEO selector to VIDEO.
3. Turn on the VCR and load a blank
cassette.
• See your VCR instruction manual for details.
4. Set the VCR's input selector to LINE,
and put it in record pause mode.
5. Turn the program selector to PLAY, and
load your recorded casette.
c (LANC) REMOTE terminal
1. Find a point on your recorded cassette
slightly ahead of the section you want
to copy.
2. Start to play it back while you monitor
the picture on the TV.
3. Start recording on the VCR as soon as
the section you want to copy appears
on the screen.
4. Pause the VCR at the end of the section
you want to copy, then stop playback
on the camera.
REMOTE
5. Repeat steps 1 to 4 until your edited
recording is complete.
The
C
(LANC) REMOTE terminal allows you to
connect the camera to equipment such as the VE-
100 Video Editor (p. 29). Some buttons on other
editing equipment may operate differently from
those on the camera.
Notes:
• The quality of the edited tape will be slightly lower
than that of the original.
• C (LANC) is a trademark. It stands for Local
Application Control Bus System.
Advertisement
Table of Contents
