Adjusting Drawer Alignment - U-Line U-1224DWRINT-00A User Manual & Service Manual

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
Drawers
CHECKING DRAWER ALIGNMENT
The unit's drawers are aligned at the factory before
shipment. However, their alignment could have been
disturbed during shipment or during overlay panel
installation. Check each drawer to confirm that it is
aligned:
Aligned
Top-to-Bottom
Side-to-Side
• — When viewed from the top, the
drawer front should be square with the sides of the
cabinet.
Front-to-Back
• — When viewed from the side, the
drawer front should be straight with the cabinet's sides,
not cocked forward or back.
Top-to-Bottom
• — When viewed from the front, the
drawer should be level horizontally.

ADJUSTING DRAWER ALIGNMENT

!
WARNING
SHOCK HAZARD — The unit must be unplugged
from the wall outlet during drawer removal,
adjustment and re-installation.
Aligned
Front-to-Back
Aligned
Side-to-Side
DRAWER REMOVAL
1. Confirm that the unit is
unplugged from wall outlet.
2. Unplug the drawer's
connection wiring (top
drawer only).
3. Remove the mounting
screws.
4. Pull the drawer completely out of the unit.
!
CAUTION
Use care when handling the drawer. Drawer
edges, drawer rail and the unit's slide may be
sharp.
NOTICE
Drawer adjustments are made by moving the
slide that carries the drawer's rail. Minor
adjustments may be made by loosening one of
the slide's mounting screws, adjusting the slide
and retightening the screw. Severe adjustments
may be made by removing the slides' mounting
screws, drilling new mounting holes and
remounting the slide.
17
Mounting
Screw
Drawers 1