Advertisement
OmniJoin
adaptor
TM
Cable connectors
+24V
GND
Connector of the original fan
Make sure to correctly
identify the GND and
+24V leads of the
original fan!
After you've identified the individual leads, please
proceed with the following steps to install the
OmniJoin
adaptor:
TM
Step 1
Cut off the connector of the fan that was originally used
in the device. Make sure not to cut the cable directly at
the connector, there should be least 2-3cm of cable left:
2-3cm minimum!
Step 2
Then take one of the supplied cable connectors and
insert the GND lead of the original cable and the black
lead of the OmniJoin
TM
adaptor into the two holes of
the cable connector. Make sure that both leads are fully
inserted and pushed all the way back.
Step 3
Then use flat nose pliers to push down the yellow button
of the cable connector. Make sure that the button is
not jammed and pushed all the way down. If the button
is jammed, push it down from both sides of the cable
connector using the flat nose pliers.
Repeat step 2 and 3 for the +24V lead.
NOCTUA NF-A4x10 24V PWM
INSTALLATION MANUAL
After you've fixed the original fan's cable to the
OmniJoin
adaptor using the cable connectors, simply
TM
connect the NF-A4x10 24V PWM to the adaptor in
order to use it in your device.
Cleaning and maintenance
4
In order to maintain maximum performance, please
clean your fans regularly using a duster, slightly moist
tissue or canned air. Please be careful not to use too
much force in order to prevent any damage to the fan.
Please don't use a vacuum cleaner as this may apply
excessive force to the fan.
In order to ensure flawless operation over many years
of usage, the NF-A4x10 24V PWM's premium grade
SSO2 bearing is fully sealed to prevent the entering of
fine dust particles.
Please note that the fan is not designed to be taken
apart by the user. Removing the impeller from the
frame will break the sealing of the bearing and results
in a loss of warranty.
!
Warranty, support and FAQs
Even with high-grade products and strict quality
control, the possibility of defects cannot be eliminated
entirely. Therefore, we aim at providing the highest
possible level of reliability and convenience by offering
a warranty period of 6 years and direct, fast and
straightforward RMA service.
Should you encounter any problems with your
NF-A4x10 24V PWM, please don't hesitate to contact
our support team (support@noctua.at).
Please also consult the FAQ section on our website:
faqs.noctua.at
Advertisement
