Related Manuals for BASIS AUDIO SIGNATURE Series
Summary of Contents for BASIS AUDIO SIGNATURE Series
- Page 1 BASIS AUDIO, INC. 2000 SIGNATURE SERIES TURNTABLE USER’S GUIDE 26 Clinton Drive, Unit 116, Hollis, NH 03049 ▪ T: 603-889-4776 ▪ F: 603-889-5402 ▪ Email: basisaudio@aol.com www.basisaudio.com...
- Page 2 INTRODUCTION Thank you for purchasing the BASIS 2000 turntable. We are confident that you will come to view your decision to use a BASIS turntable as one of the most musically rewarding equipment choices in your audio experience. The incredible precision of the BASIS bearing and platter system will allow you to feel the emotion of the music’s natural flow.
- Page 3 housing, and a subsequent loss of the bearing oil. This would necessitate refilling of the bearing, and could permanently damage carpeting or any fabric onto which the oil might spill. In the “Misc.” box locate the 2 6-32 x 1/2” long bearing screws and the long hex wrench that fits these screws.
- Page 4 Locate the Belt. Loop the belt around the lower, smaller diameter surface of the pulley and the platter. Guiding the belt at the pulley with one hand to be sure that it does not jump off the pulley, slowly rotate the platter with your other hand to cause the belt to find its natural position on the platter.
- Page 5 QUESTIONS AND ANSWERS CONCERNING THE 2000 TURNTABLE Question: “What are the sonic affects of raising or lowering the sub chassis by turning all 4 pods a certain number of turns?” Answer: There are none. This merely adjusts the height of the sub chassis, which does not affect the sound.
- Page 6 BASIS or an authorized service representative. Should this product fail to meet the above warranty purchaser assumes obligations to re- package and return the unit to the dealer, BASIS AUDIO, INC., or a designated service representative at his/her own expense.