1 Warning Caution: • Pb free solder has a higher melting point that standard solder; Typicall the melting point is 50 - 70°F (30 - 40°C) higher. Please use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder- ing iron, please be careful not to heat too long.
4 Disassembly and Assembly Instructions 4.1. Disassembly Instructions Follow the procedure below to disassemble the main unit. 1. Remove the cap, the outer foil with foil frame and the inner blade. 2. Slide the trimmer handle up to open the trimmer and unhook the trimmer handle by inserting something like a slotted screwdriver or plastic spatula into a slit.
Page 7
4. To remove the trimmer driving bar or the slit blade driving bar, press bars outward. 5. Loosen a screw and remove the bottom cover. 6. To remove the side panels, insert a small slotted screw- driver into the middle of housing and unhook. NOTE: Unhook the rear side, front side and upper side of side panel in order.
Page 8
7. Insert a slotted screwdriver into the space between the front panel and housing. Unhook the front panel by lifting the screwdriver up. 8. Loosen four screws on both front and back side of hous- ing. 9. Take out the housing B.
Page 9
10. And take out the battery assembly from housing A. 11. Remove the motor assembly and tube holder. 12. Remove the battery o-ring and washer in each battery. Take out the rechargeable batteries from the chassis.
Page 10
4.2. Cautions in Assembly NOTE: When reassembling, replace the new waterproof rubber. Make sure whether there is NO foreign substance sticking around a part covered with water seal. 4.2.1. Motor Insert the tube into the projection of the housing A and set the tube holder firmly.
Page 11
4.2.3. Rechargeable batteries Insert the rechargeable batteries into chassis. Attach the bat- tery o-ring and washer to the battery. Put the battery assembly from the battery terminal side into housing A, and insert the motor side into housing A. NOTE: While setting the battery assembly, pull the lead wires out in order to prevent pinching.
Page 12
4.2.5. Side panel Set the side panel on the body and insert the projection on top of side panel into the housing first. Then hook the front side and the rear side of the side panel in order. NOTE: Make sure that the left and right side panels are firmly fitted on both rear and front side.