Plugging In This Unit - Yamaha RX-V795a Owner's Manual

Plugging in this unit

• After completing all connections, plug the AC power cord
into an AC outlet.
(*1)
(*1):
AC OUTLET(S)
(U.S.A., Canada, China, Singapore and General models)
.......................................................... 2 SWITCHED OUTLETS
(Australia model).................................. 1 SWITCHED OUTLET
Use these to connect the power cords of your components to
this unit.
The power to the SWITCHED outlets is controlled by this unit's
STANDBY/ON switch or the remote controller's POWER and
STANDBY keys. These outlets will supply power to any
connected unit whenever this unit is turned on.
The maximum power (total power consumption of components)
that can be connected to the SWITCHED AC OUTLET(S) is
100W.
REAR
(SURROUND)
IMPEDANCE SELECTOR
SET BEFORE POWER ON
REAR : 6 MIN. /SPEAKER
CENTER : 6 MIN. /SPEAKER
MAIN A OR B: 4 MIN. /SPEAKER
A B: 8 MIN. /SPEAKER
REAR : 8 MIN. /SPEAKER
CENTER : 8 MIN. /SPEAKER
MAIN A OR B: 8 MIN. /SPEAKER
A B:I6 MIN. /SPEAKER
AC OUTLETS
SWITCHED
I00W MAX.TOTAL
CAUTION
SEE INSTRUCTION
MANUAL FOR CORRECT SETTING.
• Unplug the AC power cord from the AC outlet if this unit is
not to be used for a long period of time.
(General model)
VOLTAGE SELECTOR
(*2):
Voltage Selector (China and General Models
only)
The voltage selector on the rear panel of this unit must be
set for your local main voltage BEFORE plugging into the
AC main supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
PREPARATION
(*2)
To AC outlet
25