Connections; Audio/Video Source Equipment - Yamaha RX-V795a Owner's Manual

PREPARATION

Connections

Caution: Plug in this unit and other components after all connections are completed.
All connections must be correct, that is to say L (left) to L, R (right) to R, "+" to "+" and "–" to "–". Also refer to the owner's manual for
each of your components.

Audio/video source equipment

Use RCA type pin plug cables for audio/video units with the exception described later.
The output (or input) terminals of YAMAHA audio/video units numbered as 1, 3, 4, etc. on the rear panel must be connected to
the same-numbered terminals of this unit.
Basic connections
Turntable
FM
ANT
GND
AM
ANT
GND terminal (For turntable use)
(*1):
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
disconnected.
14
LD player, DVD player, etc.
(*1)
GND
75 UNBAL.
CD DVD/LD
OPTICAL COAXIAL
DIGITAL SIGNAL
S VIDEO VIDEO
ON SCREEN SELECTOR
IN OUT
MONITOR
DVD/LD VCR
S VIDEO SIGNAL
IN (PLAY) OUT (REC)
1 3
TAPE/MD
PHONO CD
MD recorder,
CD player
Tape deck, etc.
TV monitor
EXTERNAL DECODER INPUT
MAIN CENTER SURROUND
DVD/LD TV/DBS
OPTICAL
IN OUT
SUB
REMOTE
WOOFER
CONTROL
IN OUT
DVD/LD TV/DBS VCR
OUT
VIDEO SIGNAL
IN OUT
4
DVD/LD TV/DBS VCR
AUDIO SIGNAL
TV/Satellite tuner
: Indicates the direction of signals.
(U.S.A. model)
MONITOR
OUT
Video cassette
recorder