Product Disposal Instructions; Fcc Compliance Statement - RockJam RJK-POP-SOLO User Manual

Product Disposal Instructions

The symbol shown here and, on the product, means that the product is classed as
Electrical or Electronic Equipment and should not be disposed with other household or
commercial waste at the end of its working life.
The Waste Electrical and Electronic Equipment (WEEE) Directive (2012/19/EU) has been put in
place to encourage the recycling of products using best available recovery and recycling techniques
to minimise the impact on the environment, treat any hazardous substances and avoid the increase
of landfill.
When you have no further use for this product, please dispose of it using your local authority's
recycling processes. For more information please contact your local authority or the retailer where
the product was purchased.

FCC Compliance Statement

This device complies with Part 15 of the Federal Communications Commission
(FCC) Rules. Operation is subject to the following two conditions: This device may
not cause harmful interference. This device must accept any interference received,
including interference that may cause undesired operation.
CAUTION:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the manufacturer's instructions, may cause interference harmful to radio communications.
There is no guarantee, however, that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and
receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected. Consult the dealer or an experienced radio or TV technician for help.
10