Table of Contents
Advertisement
Protective cap (Accessory)
Shape
Material
NBR
Note) If you mount the protective cap, please use the "option cable" or use the cable of "nut
portion is 15 DIA. or less, or 14 HEX. or less."
Cable (option)
Straight
L type
①Zinc die casting
Material
(Nickel plating)
Cable
length(L)
Conduct cross
section
Core diameter
including
insulation
External cable
diameter
3. Installation
Install in a location where vibration and shock can be minimized and without direct sunlight to
the unit. And this device is waterproof equivalent (Standard: IEC 60529) to IP67 or IP65 (Gage
pressure). However, for longer, select a location that is little moisture or dust, and is not affected
by dump, dust, oil or water.
● Piping
During the installation, use wrench (Width across flat: 27mm) on the hexagon while ensuring
no excess force is applied to the unit. For tightening torque, please check the strength of
installed material with referring to table below, and install.
Recommended tightening torque for the installed material SUS304
Thread size
R1/4
G1/2A
Color
If CE40 is mounted on adjacent location, it can be shut off other
communication signals by the protective cap.
Black
Also, the protective cap helps for keeping sending / receiving
parts clean.
PUR cable(Oil resistant)
②TPU
2m , 5m
2
0.34mm
(22AWG)
1.27mm
4.7mm
Recommended tightening torque
10N・m or less
6N・m or less
TY-CE40-004A
Notes
③PUR
①Stainless steel
0.34mm
Flush diaphragm type is
attached the O-ring(P18)
PVC cable
②TPU
③PVC
2m, 5m
2
(22AWG)
1.52mm
5.2mm
Remarks
Apply seal tape
7/14
Rev.3
Advertisement
Table of Contents
