Troubleshooting - Yamaha HTR-5835 Owner's Manual

Yamaha htr-5835: user guide
Hide thumbs Also See for HTR-5835:
Table of Contents

Advertisement

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, set this unit to the standby mode, disconnect the power cord, and contact the
nearest authorized YAMAHA dealer or service center.
General
Problem
This unit fails to turn
The power cord is not connected or the
on when STANDBY/
plug is not completely inserted.
ON (or SYSTEM
The protection circuitry has been
POWER) is pressed,
activated.
or enters the standby
mode soon after the
power has been
turned on.
This unit has been exposed to a strong
external electric shock (such as lightning
or strong static electricity).
No sound
Incorrect input or output cable
connections.
The input mode is set to DTS or
ANALOG.
No appropriate input source has been
selected.
Speaker connections are not secure.
The front speakers to be used have not
been selected properly.
The volume is turned down.
The sound is muted.
The input mode is set to ANALOG while
playing a source encoded with a DTS
signal.
Signals this unit cannot reproduce are
being received from a source component,
such as a CD-ROM.

TROUBLESHOOTING

Cause
Connect the power cord firmly.
Make sure all speaker wire connections on this unit
and on all speakers are secure and that the wire for
each connection does not touch anything other than
its respective connection.
Set this unit in the standby mode, disconnect the
power cord, plug it back in after 30 seconds, then use
it normally.
Connect the cables properly. If the problem persists,
the cables may be defective.
Select AUTO.
Select an appropriate input source with INPUT,
MULTI CH INPUT or the input selector buttons.
Secure the connections.
Select the front speakers with SPEAKERS A and/or
B.
Turn up the volume.
Press MUTE or any operation button of this unit to
resume audio ouput, then adjust the volume.
Set the input mode to AUTO or DTS.
Play a source whose signals can be reproduced by this
unit.
TROUBLESHOOTING
Remedy
Refer to
page
11-13
14-19
30
24
12
24
25
30
67

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents