Advertisement
2. INTRODUCTION
Lightweight, cordless pressure washer. Ideal for a range of domestic applications including cleaning vehicles, motorcycles and
bicycles. Features 17L water tank which can be detached from base for easy refilling. Unit can be powered using vehicle's 12V socket
but is also fitted with a rechargeable lithium-ion battery which provides up to 65 minutes of continuous use. Ideal pressure washer
where no mains electric supply is available, such as classic car shows and track days. Supplied with 6m hose, variable nozzle and
fixed brush, both of which include built-in detergent bottles. Fitted with accessory storage pouch, durable wheels and shoulder strap for
easy transportation.
3.
SPECIFICATION
Model No: ................................................... PW1712.V2
Battery: .........................................................Lithium-ion
Capacity: .................................................................. 17L
Hose Length: ............................................................. 6m
Maximum Pressure: ................................ 8.5bar(123psi)
Motor Power: ...........................................................60W
Operating Time: .............................................. 55-65min
Plug Type: ..............................................................3-Pin
Power Supply Cable Length: .................................. 1.5m
Supply: .....................................................................12V
Total Stop System: ............................................. 150L/hr
Water Flow Rate: ............................................. 2.5L/min
4. CONTENTS
1. Pressure washer assembly.
5. Hose with two quick release connectors
5. OPERATION
5.1.
FILLING
5.1.1.
To detach the tank from base, turn tank by ¼ turn anti-clockwise (fig.2) and lift off.
5.1.2.
Unscrew tank cap and fill from tap; replace cap.
5.1.3.
Re-attach tank to base by pushing down and turning clockwise to lock.
5.1.4.
DO NOT fill tank with detergent. Use detergent bottles supplied with the machine. Failure to do so may invalidate the warranty.
5.2.
POWER SUPPLY
5.2.1.
The washer can be powered either directly from the vehicle's 12V accessory socket or from the internal 12V battery.
5.2.2.
To select which power source to use, move the rocker switch (fig.4) to the appropriate setting. The centre ("O") setting is the "OFF"
position.
5.2.3.
If using the12V accessory socket, plug the adaptor (fig.3) into the vehicle. It is advisable to leave the vehicle engine running whilst
using the washer in this mode. Switch off and disconnect from the vehicle when not in use.
5.2.4.
For battery charging details, see section 5.
5.3.
PRESSURE WASHING
5.3.1.
Connect hose and gun (fig.5) to the machine by pulling the connector on the hose back and pushing the hose onto the gun.
5.3.2.
When connected, the pump will build up initial pressure and stop until the trigger is pulled to release the pressurised water.
The trigger will be locked on until depressing a second time.
5.3.3.
The spray pattern may be adjusted by rotating the adjusting collar (fig 5).
5.3.4.
The unit is fitted with an automatic stop switch that will turn the pump off when the trigger is released.
5.3.5.
Always discharge the pressure in the hose before removing tools.
5.4.
DETERGENT DISPENSER
5.4.1.
The detergent bottle (fig.6) can be attached/removed by a turn-lock system within the nozzle body.
5.4.2.
When filled with appropriate detergent, unscrew the adjustment collar of the spray-gun and then remove its jet assembly locking in its
locating lugs on the detergent dispenser in the holes in the nozzle body .
© Jack Sealey Limited
fig.1
2. Detergent dispenser
6. Brush attachment
Original Language Version
3.Two spare quick release connectors 4.Pressure washer gun
7. Shoulder strap.
PW1712.V2 Issue: 1 02/08/23
fig.2
Advertisement
