Technical Data - BorMann PRO BPL7500 Manual

EN
c)
Disconnect the plug from the power source from the power tool before making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
d) Store idle planers out of the reach of children and do not allow persons unfamiliar with the planer or these
instructions to operate the planer. The planers are dangerous in the hands of untrained users.
e) Maintain the planers. Check for misalignment or binding of moving parts, breakage of parts and any other
condition that may affect the planers operation. If damaged, have the planer repaired before use. Many
accidents are caused by poorly maintained planers.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to
bind and are easier to control.
g) Use the planer, accessories and tool bits etc., in accordance with these instructions and in the manner
intended for the particular type of the planer, taking into account the working conditions and the work to be
performed. Use of the planer for operations different from intended could result in a hazardous situation.
h)
Wait for the cutter to stop before setting the tool down. An exposed cutter may engage the surface leading to possible loss
of control and serious injury.
5) Service
Have the planer serviced by a qualified repair person using only identical replacement parts. This will ensure that
the safety of the planer is maintained.
SAFETY ADVICE
●Always pull the plug from the mains before making any settings or carrying out maintenance.
●Only plug-in when machine is switched off.
●If the mains cable is damaged or cut through during work, never touch the cable. Pull out the mains plug
immediately.
●Never use electrical equipment with damaged cables.
●For operating the planer for longer periods and particularly if dust that may be hazardous to health is created,
the planer should be connected to a suitable external vacuum device. Wear a dust mask.
●Make sure you only use sharp blades.
●Always keep the power cable fed to the rear of the machine.
●Never plane over metal objects, nails or screws.
●Look after your health: Wear ear protection, safety glasses and a breathing / dust mask.
●Only place the planer against the workpiece after switching it on.
●The last plate must always lay flat on the workpiece when working.
●Do not clear dust etc. from the dust outlet with your fingers. Use a piece of wood to dislodge any trapped
planning debris.
●For the planer, if the supply cord is damaged it must be replaced by a specially prepared cord available
through the service organization.
●Wait for the cutter to stop before setting the tool down. An exposed cutter may engage the surface leading to
possible loss of control and serious injury.

Technical Data

Voltage:
Frequency:
Input power:
No load speed: 16000r/min
Cable:
3
230V
50Hz
1050W
2m PVC
WWW.NIKOLAOUTOOLS.GR