Table of Contents
Advertisement
Operation
Wood Chipping
YOU MUST READ AND FULLY UNDERSTAND THE WHOLE USER MANUAL
BEFORE OPERATION.
BODY PARTS MUST NEVER BE INSERTED INTO THE INLET CHUTE DURING
OPERATION, THIS WILL CAUSE INJURY AND PERMANENT DAMAGE.
BEWARE OF TRIP HAZARDS WHILST OPERATING YOUR MACHINE. KEEP
INFEED AREA AS NEAT AS POSSIBLE.
Once the machine has been correctly setup with both Pre-Operation checks and water supply, the
machine can be used.
>
Place wood or branches into the Inlet Chute. NEVER place wood longer than the inlet with a
maximum diameter of 120mm and width of 150mm.
>
Allow the machine to pull the material into the blades before placing another.
>
Aim the outlet chippings into a suitable outlet area as shown below.
IF the machine stalls, turn off the engine and clear the obstruction. NEVER try
this whilst
the machine is operating.
Outlet
Area
26
Operator
Area
Infeed
Operator
Area
JCB-CH75100P
Instruction & User Manual
Advertisement
Table of Contents
