Re-Recording - Punch In/Out And Start Measure - Yamaha PortaTone PSR-540 Owner's Manual

Song Recording
Re-recording — Punch In/Out and Start Measure
This section shows you how to re-record a specific section of a already-recorded song.
In the eight-measure example below, the third measures through the fifth measure are
re-recorded.
Before re-recording
After re-recording
1
Insert the floppy disk into the disk drive.
2
Press the [RECORD] button to engage the Record mode.
3
Select "Song".
Use the data dial, the [+/YES] button or the [-/NO] button.
4
Press the [NEXT] button to display the Song selection
screen.
5
Select the Song you want to re-record.
Use the data dial, the [+/YES] button or the [-/NO] button.
6
Press the [NEXT] button again to display the RecMode
screen.
7
Select "MultiRec".
Use the data dial, the [+/YES] button or the [-/NO] button.
84
1 2 3
Recording start
(Punch In)
1 2 3
Previously Newly played data
played data
RecMenu=Song
002 UserSong1
RecMode=MultiRec
4 5 6 7
Recording stop
(Punch Out)
4 5 6 7
Previously
played data
8
8