Table of Contents
Advertisement
1 Introduction
1
Introduction
1.1
About this Document
This addendum provides information about the use of the Philips wireless foot switch with the following
Philips X-ray systems:
• Allura Xper FD series release 7.2
• Allura Xper FD series release 7.6
• Allura Xper FD series release 7.8
• Allura Xper FD series / AlluraClarity family release 8.1
• Allura Xper FD series / AlluraClarity family release 8.2
• UNIQ series / UNIQ Clarity family release 1.0
• Azurion release 1.1
• Azurion release 1.2
• Azurion release 2.0
• Azurion release 2.1
• Azurion release 2.2
This addendum is applicable to the type 1 and type 2 wireless foot switches. For more information about
the model types, see
You should read this addendum in conjunction with the Instructions for Use supplied with your Philips
X-ray system.
1.2
About the Wireless Foot Switch
The wireless foot switch provides the same functions as the wired foot switch delivered with the X-ray
system.
The wireless foot switch uses an RF transmitter and receiver and must be installed by a qualified service
engineer with a Philips installation kit. Contact a Philips representative for details.
NOTE
The wireless foot switch generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause interference to radio communications.
This can be determined by switching the equipment off and on. If interference is determined, contact
technical support.
There is no guarantee that a particular location will be free from radio interference and the wireless
foot switch may be susceptible to interference from other radio equipment. Such interference may cause
sporadic interruptions to the function of the wireless foot switch. If interference is determined, contact
technical support.
For technical information about the wireless foot switch as radio equipment, see
Information (page
NOTE
Under normal operating conditions, the maximum amount of time that irradiation can continue after
the release of a foot switch pedal is 100 ms.
Identification Labels
During installation, the wireless foot switch is paired with the X-ray system, so that the foot switch
activates functions only on the matching X-ray system.
A sheet of self-adhesive identification labels is supplied with the wireless foot switch. We recommend that
you use these labels to identify the foot switch and the X-ray system.
The sheet of labels provides 6 pairs of printed numbers. Attach one label to the recess in the upper-right
corner of the foot switch, and then attach the matching label to a clearly visible location on the X-ray
system. Blank labels are also provided, in case you want to use your own identification marks.
Wireless Foot Switch Addendum
Equipment Labels (page
14).
15).
5
About this Document
Technical
Philips 4523 001 21821
Advertisement
Table of Contents
