Troubleshooting - Zenith VRB210 Installation / Operating Manual | Warranty

TROUBLESHOOTING
I
PAGE 29
Some quick and easy tips to fixing problemsyourself.
ObservedCondition
Somechannelsare skippedover when
usingCH (V/A).
Picture and soundare weak or missing.
Channel.Tuning Probl.ems
Possible Cause
Thosechannels were deleted with the
CH. ADD/DELoption.
Antenna or cablesare loose.
WrongSOURCE option is being used.
Probable Sol.ution
Use CH. ADD/DELto restore channels.
SeeSETUPMenu on page 18 for details.
Tighten connectionsor replace cable.
Try all SOURCE opUons.See SETUP
menu on page 18 for details.
Recording Problems
Observed Condition
Camcorder image is not shown.
Camcorder image via A/V input to VCR
is not shownon TVscreen.
Timer recordingis not possible.
Possible Cause
Camcorder is off.
VCRSOURCE is not set to AUX.
Clockin VCRis not set to correct time.
VCRis on which disablesUmer.
Timer has been programmed
incorrecUy.
TIMERindicator tight does not appear
after programming Umer.
TIMERindicator Ughtappearsafter VCR VCRis in Timer Recordingmode.
is turned off.
Stereo Audio Record
Observed Condition Possible Cause
Stereo is not present. TV is not Stereo-compatibLe.
Program is not in stereo format.
VCRA/V Out jacks are not connected
to TVA/V In jacks.
Probabla Sol.ution
Turn camcorder on and operate
properly.
Use CH (V/A) to select AUXA/V
input channeL.
Set clockto correcttime. SeeCLOCK
menu on page 16.
Turn VCRoff to enable timer. TIMER
indicator light appearsin the VCRfront
)aneL
Reprogram Timer. See TIMERmenuon
page 17.
Reprogram Timer and turn VCRoff to
enabletimer.
Thisis the normalindication that the
VCRis in TIMER mode.
VCRAudio/Video Out is not selected
for viewing at the TV.
VCRAUDIO RECORD modeis set to SAP
or MONAURAL.
and/or Playback ProbLems
Probable Solution
No action is possible.
No action is possible.
Make A/V connections.Stereo is
avaffabLe only via A/V output from
VCR.
SeLectAUXor A/V sourceas TV input.
Set VCRAUDIO RECORD mode to
Stereo. See AUDIOMenu on page 19.