O3 Pure PE1000XLS Owner's Handbook Manual page 6

Alarm
Your O3 Pure LS unit is equipped with an internal leak detector. If a leak happens to
develop inside of the unit the sensor will set off an audible alarm. This alarm will
continue to buzz until the leak is stopped and/or the unit is unplugged. If this alarm
should occur, you should unplug the unit, turn off the cold water valve and call your
distributor for assistance.
Ozone Selection Level Button
By pressing the Ozone Level Button, you are able to select the ozone output of the unit
and choose between 3 settings. You can select the output while the unit is running
or while the unit is off. The unit will remember your selection unless there is a power outage
in which case the unit will default to the Green ozone setting. The setting descriptions below are
meant as a starter guide. Feel free to experiment and see what settings work best in your home.
No Light: Allows the unit to run without engaging the ozone generator. The Photo
Catalytic Oxidizer (Fig. h - 7) will still operate and provide a very mild cleaning action.
Green Light: This setting is usually recommended for general washing and everyday use.
Blue Light: The unit will run at full ozone output. (g.1) For whites and deep cleaning colors.
Note: The unit may briefly flash red at beginning of some fill/rinse cycles. This is usually
normal as the unit rebuilds pressure. In some instances it may also indicate a partially
clogged filter located just inside the water intake in some washing machines.
The use of your O3 Pure LS unit is very easy and convenient. As long as you install your
O3 Pure LS properly, you simply operate your washer according to the instructions
provided by the manufacturer. O3 Pure LS is designed to automatically turn on as soon
as the washer demands water for the wash cycle and again for any rinse cycles. The
only differences are that you ONLY USE THE COLD WATER setting for both the
wash and rinse cycles on your washer.
Keep in mind that the fibers in your clothes are most likely saturated with
residual detergent. It may take up to 5 washes to remove this residue. During this
initial phase your laundry water may sud and clothes especially heavier items like
bath towels may come out stiff and crusty. This is normal as the Ozone breaks
down that embedded detergent. After this initial process, your laundry will begin to be
odor free and soften up. Also it can take up to 15 washes to remove old
detergent residue
exceptional poor water quality may void the warranty on your O3 Pure LS.
you have water, especially well water with heavy mineralization and/or iron content,
as mentioned we recommend installing a prefilter directly before the O3 Pure LS.
These can be obtained at a reasonable price from your distributor. They will extend the
operation life of your new O3 Pure LS unit and enhance it's cleaning power.
Note: If hot water is used, it will dilute the effectiveness of the O3 Pure LS unit.
We suggest that you pretreat stains, just as you would without an O3 Pure LS unit. For
normal soiled laundry, you should only need a small amount of detergent or none at all.
Page 4
Using Your O3 Pure LS
from your washer itself. Excessive
Stains
Copyright © 2022 Pure Energy LLC - All Rights Reserved
iron, mineralization or
If