Advertisement
•
Once the castors are attached invert the radiator the correct way up onto its
castors and place into the desired position ensuring that it is stable and vertical.
The oil inside the radiator will be heard to settle inside this is quite normal.
Operating Instructions – Not Using the Timer
•
Ensure the Power/Heat Switch (3) is in the 'O' off position.
•
Ensure that the Mode Switch (A - below) on the Timer is in the 'I' position.
•
Insert the mains plug into the nearest socket.
•
Rotate the Power/Heat Switch (3) to switch on the radiator and select from one
of the following heat settings:
Power/Heat Switch (3) position
•
Rotate the Thermostat Control (4) to the fully clockwise position.
•
The Indicator light (2) will illuminate to show the radiator is now warming up.
•
Once the desired temperature has been reached, turn the Thermostat Control
(4) anticlockwise until the radiator just clicks off and the Indicator Light (2)
goes out, then turn the control back up clockwise very slightly. The thermostat
will now maintain the set temperature, if necessary, further increasing or
decreasing the Thermostat Control (4) may be required to 'fine tune' the ideal
room temperature.
•
If desired rotate the Thermostat Control (4) clockwise to increase the room
temperature or anticlockwise to reduce room temperature.
•
After use, switch the radiator off by rotating the Power/Heat Switch (3) to the
'O' position.
The Indicator Light (2) will go on and off during use to show the set temperature
is being maintained, this is quite normal.
Operating Insructions – Using the Timer
The radiator is fitted with a 24-hour type timer.
This has 96 segments around the outside; each segment is equivalent to 15
minutes in time.
IMPORTANT – RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
I
II
III
2000W Oil Filled Radiator with Timer
Model No. HEA1782
Heat Setting
Low Heat
Medium Heat
Full Heat
User Manual
9
Advertisement
