If your existing wireless network has WEP encryption enabled, you need to
configure the wireless adapter with the identical encryption settings in order to
establish a connection.
Step 1
Verify that the Wireless network name matches the SSID of the Access
Point you're trying to connect to.
Step 2
Verify the Authentication Mode is set to the same setting as the Access
Point you're trying to connect to.
Step 3
Select WEP from the Data Encryption drop-down menu.
Step 4
Choose the
Step 5
Enter the identical key in the corresponding key number
Step 6
Make sure the default key is the same key number used by the Access
Point.
Note: both the key and the key number must be identical with the Access Point.
Step 7
Click OK to save your settings.
Step 8
Click Apply and OK.
3.3 Configuring WPA-PSK/WPA2-PSK Encryption
If your existing wireless network has WPA-PSK or WPA2-PSK encryption
enabled, you need to configure the wireless adapter with the identical encryption
settings in order to establish a connection.
Step 1
Go to the Properties screen of the preferred WLAN as described above
and verify that the Wireless network name is the SSID of the Access Point you're
trying to connect to.
Step 2
Choose WPA-PSK or WPA2-PSK from the Authentication Mode.
Select TKIP or AES as the Data Encryption and click on the Authentication
Config button.
same Key length
that the Access Point is using.