Using The Total Crushing Pitcher - Ninja BN805A Series Owner's Manual

USING THE TOTAL CRUSHING® PITCHER
IMPORTANT: Review all warnings
on pages 4–7 before proceeding.
IMPORTANT: As a safety feature, if the
pitcher and lid are not properly installed,
the timer will display "... ..." and the
motor will be disabled. If this happens,
repeat step 5 on the following page.
When the pitcher and lid are properly
installed, the program button LEDs will
illuminate, indicating the appliance is
ready to use.
NOTE: Auto-iQ® programs have pauses and
changes in speed throughout the cycle.
NOTE: DO NOT add ingredients before
completing installation of the Stacked
Blade Assembly.
NOTE: If the Stacked Blade Assembly is
not fully seated, you will not be able to
install and lock the lid.
NOTE: The pitcher lid handle will not fold
down unless it is attached to the pitcher.
12 ninjakitchen.com
1
Plug in motor base and place on a clean,
dry, level surface such as a countertop
or table.
2 Lower the Total Crushing Pitcher onto
the motor base. The handle should
be aligned slightly to the right and the
pitcher should be oriented so the LOCK
symbols are visible on the motor base.
Rotate the pitcher clockwise until it
clicks into place.
3 Exercising care, grasp the Stacked
Blade Assembly by the top of the shaft
and place it onto the drive gear inside
the pitcher. Note that the blade assembly
will fit loosely onto the drive gear.
4 Add ingredients to the pitcher. DO NOT
add ingredients past the MAX LIQUID
line on the pitcher.
5 Place the lid on the pitcher, aligning
the triangle symbol on the lid with the
triangle symbol on the handle. Press
down on the handle until it clicks into
place. The triangle symbols MUST be
aligned for the lid to lock and the unit to
operate. Once the lid is locked in place,
press the Power button to turn unit
on. The available program buttons will
illuminate and the unit will be ready
for use.
6a If using an Auto-iQ® program, first select
the program that best suits your recipe.
The preset feature will automatically stop
at the end of the program. To stop the
unit at any time, press the currently active
button again.
6b If using a manual program, select your
desired speed. Once the ingredients
have reached your desired consistency,
press the active button again, and wait
for the unit to come to a complete stop
after 60 seconds.
7 To remove the pitcher from the motor
base, turn the pitcher counterclockwise
and then lift up.
8a To pour out thinner mixtures, ensure
the lid is locked in place, then open the
pour spout cap.
8b For thicker mixtures that cannot be
emptied through the pour spout,
remove the lid and Stacked Blade
Assembly before pouring. To remove
the lid, press the RELEASE button and
lift the handle. To remove the blade
assembly, carefully grasp it by the
top of the shaft and pull straight up.
The pitcher can then be emptied.
9 Turn the unit off by pressing the Power
button. Unplug the unit when finished.
Refer to the Care & Maintenance section
for cleaning and storage instructions.
ninjakitchen.com
13